UniLight Emitter Chip, 3W - Green POINT-015x2-GN
Basic emitter chip in RED, GREEN, WHITE, WARMWHITE, ORANGE and BLUE
High-performance LED-module with 1,5W reference power. Ready to use for operation with 2S LiPo (ca. 8V). With 3S (12V), the additional enclosed resistor has to be used. Alternatively you can use a 8W-3S adaption cable.
Electricity: 13W reference power, 8(12)V, 3A
Beam angle: ~120°
Light intensity: ~84 Lumen RED
Light intensity: ~120 Lumen RED
Light intensity: ~228 Lumen WHITE
Light intensity: ~228Lumen WARMWHITE
Dimension: D22, LED-Chip D5x5mm
Weight: 2g (without cable)
Ready to use with 1m connection cable and series resistor for 2S, resistor for 3S enclosed
The reference power is a comparison value between our offered lights. It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.
The luminaire is ready to use for operation with 2S LiPo (ca. 8V). With 3S (12V), the enclosed resistor has to be added. Please note that high-performance LEDs can get very hot, up to 70°C is quite normal. These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible. If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED!
