UniLight 7mm Pro Strobe Light, 5Wx2, Flat - White PRO7X-050x2-WE
Miniature flashlight in extremely flat design!
Sufficient radiation to comply the SERA 923/2012 with 1 §§ 17 and 19 Par. 7 of the Air Traffic Order as position light.
Transparent polycarbonate cover and flat heat sink allow installation in almost any drone.
Electricity: 5Wx2 reference power, 8(12)V, 0.4A
Abstrahlwinkel: >120°
Light intensity: ~90 LUMEN RED
Light intensity: ~180 LUMEN GREEN
Light intensity: ~330 LUMEN WHITE
Dimension cap: 7.5x19x6
Weight: 1.5g (without cable)
With 0.5m teflon cable and pre-assembled resistor for 2S, resistor for 3S enclosed
The reference power is a comparison value between our offered lights. It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.
The luminaire is ready to use for operation with 2S LiPo (ca. 8V). With 3S (12V), the enclosed resistor has to be added. Please note that high-performance LEDs can get very hot, up to 70°C is quite normal. These lamps with heatsink cases are suitable for continuous operation if an air flow (during flight) is possible. If this is not the case, the duty cycle of 5-10 minutes should not be exceeded. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED!
