PowerBox Sensor Switch 7.4v 6311 with JR Connectors Replaced by the V3 6330
For those modellers that want to use a high voltage 2s system but want a switch that will work at those voltages safely and with a regulated 7.4 volt supply giving consistent servo speed.
This fantastic Powerbox Switch is not just a switch.
It combines a pair of independent regulated 5 amp receiver outputs all mounted in a neat twin switch housing with battery leds.
•Power handling up to 5.0 Amps (according to heatsink)
• Power supply: ◦2 x 2-cell LiPo battery, 7.4 Volt
◦2 x 5-cell NiCd or NiMH batteries
◦2 x 2-cell LiFePo battery (A123)
•Two independent linear voltage regulators, supplying 5.90 Volts •Two independent electronic switches •Two volt controller ( in 4 steps ) for each battery NEW •Two Low voltage memory for both batteries NEW •SET button for On / Off switching protection •LED indicators for both power circuits •Operating voltage range 4.0 to 9.0 Volts •Temperature range -10° to +75° C •Voltage loss approx. 0.35 Volts •Weight only 35 grammes incl. all cables
| Operating voltage |
4.0V - 9.0V |
| Power supply |
2S LiPo, 2S LiIon, 2S LiFePo, 5S NiCd/NiMH |
| Current drain Power-on state |
30mA |
| Current drain Standby |
5µA |
| Maximum load current |
Peak 2x4A |
| Drop-out voltage |
0.3V |
| Output voltage |
7.4V regulated |
| Dimensions |
65 x 23 x 26 mm |
| Weight |
35g |
| Temperature range |
-30°C to +75°C |
Please follow this link for the manual. http://www.powerbox-systems.com/shared/download/bedienungsanleitungen/PowerBox_Sensor_englisch_f.pdf
6311
